How do i get the props off the reverse gearboxes?

niander · Post by **niander** » Thu Feb 24, 2011 12:47 am

How do i get the props off the reverse gearboxes?the pin seems very tight?

niander · Post by **niander** » Thu Feb 24, 2011 10:01 pm

Is it just the pin that should knock out?
cheers

Post by **RickUK** » Fri Feb 25, 2011 9:47 am

Yep - drive the pin out with a well fitting punch (to stop the pin burring over) take the collar off, and then the whole prop assembly (prop, drive spring, and hub, at which point you will see the drive pin through the prop shaft.
Before reassembly, clean, lubricate the prop hub so that the prop is free to turn on it, and the outer collar, which should be a good but not overtight fit.

niander · Post by **niander** » Sat Feb 26, 2011 11:18 am

thanks the pin seems very tight
and dosent want to move!

Saving Old Seagulls

How do i get the props off the reverse gearboxes?

How do i get the props off the reverse gearboxes?

Re: How do i get the props off the reverse gearboxes?

Re: How do i get the props off the reverse gearboxes?

Re: How do i get the props off the reverse gearboxes?