You have a 10 thou oversize in your olympic, they machined a 10 over for the reconditioning dept, but never had to use them as the bores never needed reboring & it was cheaper to dump the cylnder if it was too bad, it's belived that all the + 10s were sent your direction for them.
Seagull had several people casting their pistons, Hepolite, some firm in India & some from Italy, Asso?
I can't remember where I put the notes as it was 6 or 7 years ago that Charles & I were researching that.
Make it idiot proof and someone will make a better idiot.
Yes, I have seen that you use it and searched to see the properties of this product. Looked promising so since my brother was in UK for Easter vacations I asked him to bring me a tube. After I tried it, I use it all the time. The great advantage comparing to RTV is that you don't have to wait to cure. For RTV I have to wait 24hours to see what I have done.
In addition I like teasing a little bit C-I about RTV etc
It must be even better in spray as it will an even layer!
I also love your hammer. I have a flat one, I will search for one like yours. Should cuts gasket really nice.
to see what I have done.
