Saving Old Seagulls

Yep, they will come up well. Be stronger that flat back tails.

I never noticed that the std brackets tails were different. Either way.

Those look great, Nudge..!

I will get all the bits boxed up over the weekend so I can find out the total costs and let people know by Skype or PM.
After all the parts are boxed then I will post up if there are any parts left.

Nice, one, looking forward to seeing the hardware. How many have you sold out of curiousity?

I still have 4 transom brackets. I will keep one of them to turn into a new pattern as Hugs would like his Ali one back.
The one I will keep is not that good due to shrink in places that are seen. I can fix that with filler on the pattern.

There are no more "A's" but if more are required I can get some more, they are not that bad to make.

I still need to get them boxed up so I can find out how much the shipping will be.

I have sent Pm's out to those that have ordered parts.

Hugz parts are on there way!

Boy am I impressed! Brilliant job Chris. Puts the rest of the motor to shame. Left click to enlarge... you know the drill. 5/16 bsf thread.

Thanks is not enough.....

Good stuff, That got there a lot quicker than the last lot!

Looks like it has been there all its life!

you know the drill. 5/16 bsf thread.

I think I used a 6.5mm drill, it should be 6.8mm but I have the set of 3 taps.

My parts have arrived A little fettling and machining to finish, and studs to drill, tap and fit. Nice job Nudge

Well it looks kinda close to what it should!

It certainly does

I've just obtained another skeletal bracket, that's short of its tilt V strut. Are there any left from the cast batch?

I will have a look at what I have and get back to you.

I have only got 3 sets of the skeletal bracket bits left.
I still have the pattern for the "A" never had one for the "V"

Yes, bronze A bracket is the part I'm missing