Page 1 of 1
Marston/SD flywheel puller
Posted: Wed Mar 08, 2017 9:04 pm
by NaughtyBits
Before I have one machined up, do any members have one spare they might consider selling?
Many thanks.
Re: Marston/SD flywheel puller
Posted: Wed Mar 08, 2017 9:10 pm
by NaughtyBits
Searching old topics, I understand the thread is 1 & 1/8" x 16 TPI, left hand thread...
Re: Marston/SD flywheel puller
Posted: Thu Mar 09, 2017 12:59 pm
by Michael
I have one, bring engine over and I can pull flywheel for you
Re: Marston/SD flywheel puller
Posted: Thu Mar 09, 2017 2:28 pm
by NaughtyBits
Sounds good Michael, thanks. I'm good for now, though - mine had been well greased up & came off with the slightest tap.
But I know there's a bunch more SD owners here now who'll need pullers at some point - figured it'd be a good thing to either source a couple or get a them made up for people.
Thanks though, I'll give a shout if/when in need.
Re: Marston/SD flywheel puller
Posted: Fri Mar 10, 2017 10:08 am
by Collector Inspector
Charles will chip in soon I am sure.
There were a few on SOS but they have all sold out sadly.
They are of some complexity to manufacture a decent quantity run to keep the cost to us punters down.........there may be a list of those wanting needed before any more.
BnC
Re: Marston/SD flywheel puller
Posted: Fri Mar 10, 2017 12:57 pm
by Oyster 49
I'd buy one when available.
Re: Marston/SD flywheel puller
Posted: Fri Mar 10, 2017 7:04 pm
by NaughtyBits
Oyster, I'll touch base when we make up a few.