Page 1 of 1
rotor
Posted: Mon Nov 08, 2010 11:38 pm
by roxylass
does the rotor actually sit on the jointing plate
Re: rotor
Posted: Tue Nov 09, 2010 12:33 am
by billyboy
no...... the distance between the bottom of the rotor and the top of the gasket should be about 1/16"
Re: rotor
Posted: Sat Nov 13, 2010 3:06 am
by Vic
According to Service Sheet No.9 up to 1/16" clearance is correct.
Re: rotor
Posted: Sun Nov 28, 2010 6:20 pm
by roxylass
purchased a new rotor from john, water not to great stripped her down noticed that the rotor had came down on top of the jointing plate,definitely had it set 1/16th above the plate struggle getting it back to where it should be,are these prone to working down, also if its done it once i can only guess it will happen again.