I don't recall seeing one of those before, in black plastic, but might be 3D printable.
Thanks for the pics, this might be enough to motivate someone to do a cadcam drawing & print a few samples, to see if it's possible to get a good enough finish & load bearing properties.
Locking latch
Moderators: John@sos, charlesp, Charles uk, RickUK, Petergalileo
- Charles uk
- Posts: 4960
- Joined: Wed Feb 27, 2008 4:38 pm
- Location: Maidenhead Berks UK
Re: Locking latch
Make it idiot proof and someone will make a better idiot.
Re: Locking latch
It might be but who will draw it up? and if they did would there be a demand for them.but might be 3D printable
If there was a demand I would give it a go.... It would be a good part to print in PETG
It would have cost quite a bit to have the tooling made to do that, but the parts may have been cheaper to make.
"THE KING OF BLING"!
Is it better to over think, than not think at all?
Is it better to over think, than not think at all?
- NaughtyBits
- Posts: 205
- Joined: Fri Apr 17, 2015 6:30 pm
- Location: Bermuda