wipac 2 base plate and flywheel

kev shep · Post by **kev shep** » Thu Jul 02, 2015 2:43 pm

just replaced my centry villiers system to wipac set points to 20 though when i pull start cord to start just back fire but good spark at plug any idears ?

Post by **Charles uk** » Thu Jul 02, 2015 5:01 pm

How have you set the timing?

supersaint61 · Post by **supersaint61** » Thu Jul 02, 2015 5:21 pm

is your woodruff key in place

kev shep · Post by **kev shep** » Thu Jul 02, 2015 5:31 pm

woodruff key is in place brought piston to T.D.C and set points to 18 thou

Post by **Charles uk** » Thu Jul 02, 2015 5:55 pm

Where did those instructions come from Kev?

Didn't your crankcase have the locking screw dimple?

kev shep · Post by **kev shep** » Thu Jul 02, 2015 6:05 pm

yes and screw base plate located

Post by **Charles uk** » Thu Jul 02, 2015 7:27 pm

Do you know if the crankshaft has been replaced & has the motor ever run properly during your ownership?

Horsley-Anarak · Post by **Horsley-Anarak** » Thu Jul 02, 2015 8:46 pm

Is it a forty model or a century 102 model?

With the tank furthest away from you, looking at the top of the motor,the ht outlet from baseplate should be at 8.00 o,clock for a forty model, or four o'clock for the century/102 models.

Sounds like your timing is out if it backfires, not sure why you are setting the points at T.D.C, set the points when they are fully open,just rotate the flywheel untill you see them open fully, then set with feeler gauge.

H-A

Saving Old Seagulls

wipac 2 base plate and flywheel

wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel

Re: wipac 2 base plate and flywheel