New to this board? - This may help you.

Having problems with a Seagull? - ask an expert here

Moderators: John@sos, charlesp, Charles uk, RickUK, Petergalileo

Post Reply
User avatar
charlesp
Posts: 2564
Joined: Mon Mar 06, 2006 1:37 pm
Location: Poole, Dorset, England

New to this board? - This may help you.

Post by charlesp » Mon Nov 13, 2006 10:29 am

If you're new to the Help board on this site, here is the link to the SOS Frequently Asked Questions section:

http://www.saving-old-seagulls.co.uk/faq.htm

John has compiled this and fine tuned it over the years, and it answers a lot of the common questions that crop up. A glance at the rest of the site is well worth while, and the section 'ID your Seagull' will be of interest to the new owner:

http://www.saving-old-seagulls.co.uk/i_ ... eagull.htm

Workshop manuals can be obtained through John, these are the official British Seagull publications, and they are a mine of useful information, being a compilation of a number of British Seagull service sheets.

Important. There are a number of fairly unscrupulous people out the selling pirated copies on CD or hard copy on internet auction sites. Some of the regulars on this board have reported problems, and some have reported no goods at allo arriving. These people are best avoided - and sometimes their descriptions of the models covered in their manuals are at best fanciful. The proper manual remains the best, and is reasonably priced. Contact John for more info - his details are on the main site

martin42
Posts: 1
Joined: Thu Aug 23, 2012 7:40 pm
Location: manchester

Re: New to this board? - This may help you.

Post by martin42 » Thu Aug 23, 2012 7:50 pm

hello, im a newbe, i have a 40+ gfpl and it has rusted on the shaft housing is it easy to replace or can paint it or can i get it recromed, any help thanks;

Keith.P
Posts: 2823
Joined: Wed Oct 24, 2007 7:43 pm
Location: Hertfordshire
Contact:

Re: New to this board? - This may help you.

Post by Keith.P » Thu Aug 23, 2012 10:07 pm

All depends on what kind of money you wish to spend.
You can paint, re-chrome, all the old chrome would have to go first to re-chrome, or if available a new around £50.
Or keep an eye on Fleabay for a good one.

DeadeyeDick
Posts: 4
Joined: Sun Aug 06, 2017 7:01 pm
Location: Worcestershire

Re: New to this board? - This may help you.

Post by DeadeyeDick » Mon Aug 07, 2017 7:01 pm

Gentlemen, I'm getting punch drunk scrolling through page after page of replies to the question I need an answer to, thank heavens there is a search facility to narrow it down a bit! But, every answer to the question of fuel level in a Villiers concentric (40+) bowl skirts around the problem of float level and soon seems to divert to number of mixture needle and screw being flush or a turn or two below surface of slide.

Is there a drawing anywhere of how to set the correct float level and most of all how to remove the float needle to inspect it?

Thank you.

Post Reply