Locking latch

Post your wanted adds here

Moderators: John@sos, charlesp, Charles uk, RickUK, Petergalileo

User avatar
Charles uk
Posts: 4491
Joined: Wed Feb 27, 2008 4:38 pm
Location: Maidenhead Berks UK

Re: Locking latch

Postby Charles uk » Fri Mar 08, 2019 7:18 pm

I don't recall seeing one of those before, in black plastic, but might be 3D printable.

Thanks for the pics, this might be enough to motivate someone to do a cadcam drawing & print a few samples, to see if it's possible to get a good enough finish & load bearing properties.
Make it idiot proof and someone will make a better idiot.

User avatar
Nudge
Posts: 758
Joined: Sun Feb 15, 2015 2:43 am
Location: Auckland, New Zealand

Re: Locking latch

Postby Nudge » Sat Mar 09, 2019 6:36 am

but might be 3D printable

It might be but who will draw it up? and if they did would there be a demand for them.
If there was a demand I would give it a go.... It would be a good part to print in PETG

It would have cost quite a bit to have the tooling made to do that, but the parts may have been cheaper to make.
"THE KING OF BLING"!
Is it better to over think, than not think at all?

User avatar
NaughtyBits
Posts: 204
Joined: Fri Apr 17, 2015 6:30 pm
Location: Bermuda

Re: Locking latch

Postby NaughtyBits » Tue Mar 12, 2019 1:16 pm

Crab24,

Yes, I'd made a post looking for a few of these a while back:

viewtopic.php?f=3&t=6483


Return to “Wanted”

Who is online

Users browsing this forum: No registered users and 9 guests